JUKI MOL-254 Engineer's Manual page 75

15.Install main shaft motor
16.Install main shaft sensor slit
17.Install hook removing unit
tighten the unit to hook connecting plate
18.Install hook removing motor
the hook fully up to the end of its stroke several times to perform centering, and fix fixing screws
and at the position where there is no moving torque.
19.Install hook removing shaft sensor
(Caution) When removing the hook removing unit, be sure to re-adjust the hook position.
Refer to page ? for adjusting procedure.
Disassembling / Assembling
. Refer to page 7 for the installation.
and main shaft sensor
. Temporarily tighten unit fixing screws
with fixing screw
on the hook removing unit, turn motor slit plate
. Install the sensor almost in parallel with the motor.
68
− −
. Refer to page 9 for the installation.
and
.
and temporarily
by hand, move
,