JUKI MOL-254 Engineer's Manual page 9

29) Loop cut method
30) Loop cut
31) Loop bending
32) Loop supply drive method
33) Loop length setting
34) Loop splice detection
35) Bobbin thread winder device
36) Temporary stop function
37) Bobbin thread counter
38) Fork drive method
39) Loosing loop mechanism
40) Loop pull-out mechanism
41) Needle thread breakage detector
42) Needle cooler
43) Air gun
44) Table height
45) Dimensions
46) Gross weight
47) Power consumption
48) Operating temperature range
49) Operating humidity range
50) Line voltage
51) Air pressure used
52) Air consumption
: Selection of cross cut and straight cut
(Range : 9 mm to 20 mm)
(Cross cut at the time of delivery)
: Cutting method by engaging moving knife with
counter knife
: Fork folding method
: Front and rear assisted drive method (stepping
motor)
: Automatic recognition method
: Potentiometer automatic splice detection method
: Single and separated drive
: Possible to stop the machine during sewing
: Selection method of UP/DOWN counter
(Front and rear hooks can be separately set.
Device automatically stops at COUNT UP.)
: AC servomotor (120W)
: Optional
: Optional
: Optional
: Optional
: Optional
: Provided with adjustable stand function (Manual
type)
920 mm to 1,250 mm (from floor level to top
surface of throat plate)
: Width
Length
Height
stand) (When table comes down to the lowest.)
: 2,250N (230 kgf)
: 350VA
: 5 ℃ to 35 ℃
: 35% to 80% (no dew condensation)
: AC200V, 220V, 230V, 240V, 380V, 400V ± 10
%
(Power frequency : 50/60 Hz)
: 0.5 MPa (5 kgf/cm
: 52 /min. (N
(Splice processing : 1 cyclle/min, excluding
optional)
2
− −
: 1,200 mm
: 800 mm
: 1,350 mm (excluding thread
2
)
/ min)