Setting Of The Phase Of The Power (Remodelling Of The Power Cord) - JUKI MOL-254 Engineer's Manual

2) Setting of the phase of the power (Remodelling of the power cord)

* Note : It is not necessary to remodel with the 3-phase power.
○ When changing 3-phase to single phase, it is necessary to cut one wire on the power plug side.
○ Attach a C-type ring shaped wire marker on either one of the black wires.
3-phase : 380, 400V
Black
Black
Brown
Green/yellow
➡
1-phase : 220, 230, 240V
Black
Black
Green/yellow
Black wire
Remodelling to single phase
* 2 : Wire marker
* 1 : Cut the brown wire.
Slide the wire marker in the direction of the arrow to insert.
Make the guide of wire marker bar come in close contact
with the wire as shown in the figure.
Attach the marker on either one of the black wires.
(The figure shows the connection of the neutral line (neutral).
−
* 1 : Cut the brown wire at the root of sheath.
* 2 : Insert the wire marker supplied.
See the figure below.
N
N N
184
−
Wire marker bar