I/H Lever Sensor (Left) Removal; Cover, Holder, Ic, Left Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
17. Pick up and release the two tabs securing the "I/H Lever Sensor (Left)" and
remove the "I/H Lever Sensor (Left)".
18. Disconnect connector from "I/H Lever Sensor (Left)"
(Refer to Figure 4-133.)
19. Remove the two screws securing "Cover, Holder, IC, Left" and remove
"Cover, Holder, IC, Left".
(Refer to Figure 4-134.)
C.B.S. 3x6: 2pcs.
When the "Ink Lever" is installed against the angle set
location as shown in the illustration, confirm that the two
holes of "Fan Gear, 34" form a line parallel to the bottom
of "Frame, Holder, IC".
Angle Set Location
Ink Lever
Frame, Holder, IC
Align the two dowels on holder side with the two
positioning holes on the "Cover, Holder, IC".
(Refer to Figure 4-134.)
Disassembly & Assembly
(Refer to Figure 4-133.)
Fan Gear, 34
Holes
Parallel Alignment
Disassembly Procedures
I/H Lever Sensor (Left)
Tabs
Figure 4-133. I/H Lever Sensor (Left) Removal
Dowels and Positioning Holes
C.B.S. 3x6
Figure 4-134. Cover, Holder, IC, Left Removal
Revision C
Connector
Cover, Holder, IC, Left
303