Harness, Cr; Releasing The Harness - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

4.2.7.3 Harness, CR

1. Remove "Release, Lever Unit".
2. Disconnect "Motor Assy., CR" harness (CN15: white, 2 pin) from the "C533
MAIN Board", and peel the acetate tape to release the harness.
"4.2.4.1 C593 MAIN Board" (p226).)
3. Release the "Motor Assy., CR" harness from the "Paper Guide, Lower" tab
and the two channels. (Refer to Figure 4-86.)
4. Peel two pieces of acetate tape and release "Motor Assy., CR" harness,
and then pull it out through the hole of the
5. Cut the tying band and release the "Motor Assy., CR"
Figure 4-87.)
Disassembly & Assembly
(Refer to "4.2.9.1 Release Unit" (p343).)
(Refer to
frame.(Refer to Figure 4-87.)
harness.(Refer to
Disassembly Procedures
Harness
Channels
Figure 4-86. Releasing the Harness_1
Acetate Tape
Tying Band
Figure 4-87. Releasing the Harness_2
Revision C
Tab
272