Epson Stylus Pro 4400 Service Manual page 168

EPSON Stylus Pro 4400/4450/4800/4880/4880C
PAPER CUT ERROR
LCD
PAPER NOT CUT
COMMAND ERROR
LCD
COMMAND ERROR
WRONG INK ERROR
LCD
MISMATCH ERROR
DRIVER INK SET
SETTING IS WRONG
WRONG ROLL PAPER PATH / WRONG ASF PAPER PATH / WRONG MANUAL PAPER PATH
LCD
LOAD ROLL PAPER
LOAD SHEET PAPER
IN P. TRAY
FEED SHEET PAPER
Note : Remote commands always have priority.
ASF PROHIBITIONS
LCD
FORBIDDEN MEDIA
FROM P. TRAY
FEED SHEET PAPER MANUARY
Troubleshooting
Explanation
It is occurred when top of roll paper cannot be detected by Multi
Sensor, after paper cut operation.
Explanation
This error occurs when ink type (dye / pigment / black ink type)
designated with IK command is different from Ink Cartridge installed in
the printer.
Explanation
This error occurs when ink type (4 color/ 8 color) designated with IK
command is different from Ink Cartridge installed in the printer.
Explanation
Different paper source is selected on panel from the paper source that
is selected by Remote command.
The path sent by command takes priority, and a message based on
the command designated path is displayed in the LCD if the printer
path is different.
Explanation
ASF is designated paper tray when command is received for printing
of media that is prohibited from being supplied by ASF, such as Water
Color Paper.
Troubleshooting Based on Panel Messages
Recovery
Release Paper Lever, remove paper, and pull down the lever.
Recovery
Press [Pause] key after stopping data transmission from the host.
Recovery
Install the correct Ink Cartridge displayed on the Panel LCD, and pull
down the Ink Lever.
Recovery
If the panel setting differs to the actual paper, change the select paper
in the panel.
If the actually set paper differs, reset paper selected by PP command.
Reset the panel by pressing the [Pause] key. In this case, the
mechanical parameters will follow the paper type default settings set in
the printer.
Recovery
Reset panel by pressing [Pause] key.
Revision C
168