Cutter Position Adjustment; Auto Margin Refresh; Level Structure Of Cutter Position Adjustment Menu; Level Structure Of Auto Margin Refresh - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

1.4.4.12 Cutter Position Adjustment

Cutter position can be adjusted by this mode. Cutter position adjustment
pattern is printed, and users entering the cutter position number to adjust the
cutter position.
NOTE: This adjustment is effective for top/bottom no margin print.
This mode only operates when paper type is roll paper and setting is roll paper
cut ON. Other than this, the printer displays "UNABLE TO PRINT" and stops
printing. 3 seconds later, this mode is canceled automatically and the printer
returns to standby condition.
Setting procedure
1. Set paper.
2. Enter Cutter position adjustment menu in the panel.
3. Print cutter position adjustment pattern.
4. Select the best adjustment pattern number and enter the number.
NOTE: When "1 cut" is selected in panel, it will not operate.
Cutter position adjustment pattern
Output paper size: A4
Font: Built-in font (Print all in alphanumeric characters)
Print sample: See following picture.
Figure 1-12. Cutter position adjustment pattern
NOTE: The shift amount among the pattern numbers is 1/360dpi
approx. 0.7mm.
Product Description

Level structure of cutter position adjustment menu

PRINTER SETUP
CUTTER ADJ

1.4.4.13 Auto Margin Refresh

When this setting is ON, paper edge is automatically cut and refreshed to
prevent print dirt in the situation after 4 sides no margin print in first JOB and
with margin print in next JOB. The cutting length depends on the minimum cut
length at this time.

Level structure of auto margin refresh

PRINTER SETUP
REFRESH MRGN
Operating Panel
[< / >]
CUTTER ADJ
EXEC
PRINTING
[>]
CUTTER ADJ
[>]
1
[∧ / ∨]
CUTTER ADJ
[>]
17
[∧ / ∨]
[< / >]
REFRESH MRGN
ON
[∧ / ∨]
REFRESH MRGN
[<]
OFF
[∧ / ∨]
Revision C
55