Pe Sensor/Pe Sensor Holder/Pe Lever Removal - Epson Stylus C82 Service Manual

EPSON Stylus C82
ASF Unit Assembly Points
1. Set Clutch Spring (when assembling Clutch and Clutch Gear)
2. Position Paper Back Support Lever (when setting the Paper
Back Cam to LD Roller Shaft at first step)
3. Align phase (when inserting Paper Back Cam into LD Roller
Shaft at last step)
1
Clutch Gear Clutch
3
Paper Back
Cam
Clutch Gear
Figure 4-27. Assembly Points
DISASSEMBLY AND ASSEMBLY
2 Correct State
Paper Back Support Lever
2' Wrong State

4.2.3.3 PE Sensor/PE Sensor Holder/PE Lever Removal

1. Remove ASF Unit. (See Section 4.2.3.1)
2. Disconnect connector from PE Sensor.
3. While lifting PE Sensor Holder upwards, use a pair of tweezers to release 4 hooks
holding the PE Sensor Holder starting from the upper direction of the printer by
following the order shown below. Then remove the PE Sensor and PE Lever along
with the PE Sensor Holder.
3
Hooks
1
2
<Front Side>
Figure 4-28. PE Sensor/PE Sensor Holder/PE Lever Removal 1
4. Release 3 hooks fastening the PE Sensor to the PE Sensor Holder, then remove PE
Sensor from the PE Sensor Holder.
5. Follow the order shown below to remove the PE Lever along with Torsion Spring
0.28 from the PE Sensor Holder.
PE Sensor
Torsion Spring 0.28
Figure 4-29. PE Sensor/PE Sensor Holder/PE Lever Removal 2
Disassembly
4
Hooks
Connector
PE Sensor
Hook
PE Sensor Holder
PE Lever
Hooks
2
1
PE Lever
Revision A
Hook
<Rear Side>
35