Skew Error Detection; Job Time-Out Setting; Level Structure Of Detect Skew Error Menu; Level Structure Of Job Timeout Setting Menu - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

1.4.4.10 Skew Error Detection

When this setting is set to "OFF", a paper skew error is not occurred and
printing operation is continued. Even if this setting is set to "ON", cut paper
skew is not detected after printing.
Even if the printing image is outside the paper because of the paper not
straight by the setting, the printer doesn't inform the error, so users have to set
up at their own responsibility.
Skew error detection is only enabled when roll paper is selected in the printer
setting menu. Paper width detection is carried out when paper width detection
is ON even if Skew error is set to OFF.

Level structure of detect skew error menu

PRINTER SETUP
PPR ALIGN CHK
[<]
Product Description
[< / >]
PPR ALIGN CHK
ON
[∧ / ∨]
PPR ALIGN CHK
OFF
[∧ / ∨]

1.4.4.11 Job Time-out Setting

When print data is interrupted more than setting time although data receiving is
available, the print job is regarded as an end, and the printer runs paper
feeding operation.
If an I/F is fixed by remote command "DP" in duplex print setting in the driver,
job time-out setting is unable to function.

Level structure of job timeout setting menu

PRINTER SETUP
Operating Panel
[< / >]
TIME OUT TIME OUT
OFF
[∧ / ∨]
TIME OUT
[<]
30sec
[∧ / ∨]
TIME OUT
[<]
60sec
[∧ / ∨]
TIME OUT
[<]
180sec
[∧ / ∨]
TIME OUT
[<]
300sec
[∧ / ∨]
Revision C
54