Ink Discharge - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

5.3.18 Ink Discharge

Before removing the Damper (Valve Assy., Head), discharge the ink remaining
in the equipment by following the procedure below.
Procedure
1. Turn the printer power on.
2. Start up the adjustment program and select [Ink Discharge].
3. Click the [Run] tab.
4. When a pop-up window appears, click [OK].
5. Confirm that the "Please Remove Ink" message is displayed on the
LCD, and pick up the ink levers on both sides to remove all the ink
cartridges.
6. Press "Menu(>)" to display "Set Lever (L/R)", and lower the ink
levers.
7. Press "Menu(>)" to change the display to "Dischg. Washfluid". The
ink discharge begins at this time.
8. The display turns to "Set Cleaning I/C" when the ink discharge is
finished. Pull up the ink levers on both sides to install the ink
cartridges.
9. Press "Menu(>)" to display "Set Lever (L/R)", and lower the ink
levers.
10. Press "Menu(>)" to start the head cleaning. The display changes to
"Head Cleaning".
11. The display turns to "Please Remove CL I/C" when the head cleaning
is completed. Pull up the ink levers on both sides to remove the ink
cartridges.
12. Press "Menu(>)" to display "Set Lever (L/R)", and lower the ink
levers.
13. Press "Menu(>)" to discharge the cleaning liquid. The display changes
to "Dischg. Washfluid".
14. Click [Finish] on the Ink Discharge screen when the discharge is
finished.
Adjustment Basic Adjustment
Figure 5-56. Ink Discharge
Revision C
411