Pulley, Driven/Shaft, Pulley; E-Ring And Plain Washer Removal; Loosening Cr Tension - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

4.2.7.10 Pulley, Driven/Shaft, Pulley

1. Remove "Cover, Side, Left" (p216).
2. Remove the E-ring that secures the "Shaft, Pulley" on the left back of the
printer, and then remove the plain washer.
3. While pressing the "Lever, Rock, PG", loosen the CR tension attachment
screw until its tip gets behind the "Pulley, Tension, CR".
(Refer to Figure 4-102.)
Disassembly & Assembly
(Refer to Figure 4-101.)
Disassembly Procedures
E-ring
Plain washer
Figure 4-101. E-ring and Plain Washer Removal
Lever, Rock, PG
Attachment Screw
Figure 4-102. Loosening CR Tension
Revision C
Pulley, Tension, CR
282