Harness Routing; Harnesses On Left Side Of Printer; Pg Sensor Harness; Csic / I/H Lever Sensor Harness - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

4.2.10 Harness Routing

This section explains cautions and points in routing the harnesses. Referring to
this section, route the harnesses correctly. For the sections that is not
described here, refer to the corresponding diassembly/assembly procedures.

4.2.10.1 Harnesses on Left Side of Printer

PG Sensor • Harness
Should be secured with the parts below.
Clamp: 1 pc.
Acetate tape: 1 pc.
Clamp
Figure 4-223. PG Sensor • Harness
Disassembly & Assembly
CSIC / IH/ Lever Sensor • Harness
Should be connected to the "C593_SUB-C Board" through under the sheet
as shown in the figure below.
Should be secured with the parts below.
Get through under the sheet
Acetate tape
Disassembly Procedures
Acetate tape: 2 pcs.
Figure 4-224. CSIC / I/H Lever Sensor • Harness
Revision C
Acetate tapes
358