Releasing The Tube, Supply, Ink; I/H Left Unit Front Side - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
When performing the following step, be careful not to bend
C A U T I O N
the "Tube, Supply, Ink" or scratch it with the edge of the
frame.
8. Peel acetate tape and release the four "Tube, Supply, Ink" from the notch
of the frame. (Refer to Figure 4-127.)
The width of the frame notch allows passage of one tube at a
C A U T I O N
time. Be sure to release each tube in order.
When installing "Tube, Supply, Ink" to the frame, secure
it with acetate tape.
The "Tube, Supply, Ink" should be slackened to the
direction (center of the printer) as shown in
For the 4-color model, place all the eight "Tube, Supply,
Ink" in the notch on the left frame, and secure them with
acetate tape.
9. Remove the two screws securing the front side of "I/H Left Unit".
(Refer to Figure 4-128.)
C.B.S. 3x6: 2 pcs.
Disassembly & Assembly
Notch
Figure 4-127.
Disassembly Procedures
Acetate Tape
Tube, Supply, Ink
Slack Direction
Figure 4-127. Releasing the Tube, Supply, Ink
C.B.S. 3x6
Figure 4-128. I/H Left Unit Front Side_1
Revision C
I/H Left Unit
299