"Shaft, Pulley" Removal; Pulley, Driven And Shaft, Pulley Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
4. Pull the "Holder, Pulley" toward you, and then remove the "Shaft, Pulley"
upward from the front and rear grooves on the "Holder, Pulley" together
with the "Belt, CR" and the "Pulley, Driven".
5. Remove the "Belt, CR" from the "Pulley, Driven".
6. Draw out the "Shaft, Pulley" from the "Pulley, Driven" to remove the two
polysliders. (Refer to Figure 4-104.)
7. Remove the ball bearings from the "Pulley, Driven".
(Refer to Figure 4-104.)
Install the "Pulley, Driven" and "Shaft, Pulley" with the
grooved end of the "Shaft, Pulley" facing the rear of the
printer.
Disassembly & Assembly
(Refer to Figure 4-103.)
Disassembly Procedures
Holder, Pulley
Figure 4-103. "Shaft, Pulley" Removal
Polyslider Ball bearing Pulley, Driven
Ball bearing
Figure 4-104. Pulley, Driven and Shaft, Pulley Removal
Revision C
Assemble
Belt, CR
Groove
2
Pulley, Driven
Shaft, Pulley
1
Polyslider
Shaft, Pulley
283