Ricoh C211 Service Manual page 658

9. Table of Defective Electrical Components: SS830
Component Condition
Phenomenon
Second Paper Exit ON condition When the main switch is turned on, jam in-
Sensor
(Paper present) dicators "G" + ~ blink.
OFF condition
After one sheet of paper is printed, the
(Paper does not machine stops and jam indicators "E" + ~
present) blink.
Paper Feed OFF condition
The paper is not fed and jam indicators "B"
Solenoid
+ ~ blink.
Drum Rotation ON condition The drum begins to rotate when the main
Sensor
(Interrupted)
switch is turned on.
E06 lights when the
Start key is pressed.
OFF condition
The drum begins to rotate when the main
(Not interrupted)
switch is turned on.
E06 lights when the
Start key is pressed.
Master End Sensor ON condition
Normal operation when a master is present.
(Actuated)
Master end is not detected; Master End in-
dicators "C" + fi do not blink and jam in-
dicators "C" + ~ blink.
OFF condition Even if the master is present, the Master
(Not actuated)
End indicators "C" + fi blink.
Right Cutter Switch ON condition The master is not cut. (Cutter unit does not
(Rear) (Feeler is
move at all.)
actuated)
OFF condition When the master button is depressed, in-
(Feeler is not
dicator "E-01 "lights. At that time, the cutter
actuated)
does not return to the front position.
Left Cutter Switch ON condition The master is cut. (Cutter unit does not
(Front) (Feeler is
return from the rear.)
actuated)
OFF condition
When the main switch is turned on, indicator
(Feeler is not
"E-01" lights.
actuated)
When the master button is depressed "E-01
lights. (Master is cut) If switch fails during
machine operation, "E-01" lights.
6-36
Rev. 8189