Ricoh C211 Service Manual page 459

[A]
la
When the drum turns 70 degrees past the second drum position sensor, the master eject
solenoid [A] turns off, separating the lower first eject roller [B] from the drum.
When the ejected master is between the upper and lower
first eject rollers, it activates the
master eject switch [C]. After that, the master is stacked into the master eject box [D].
Master Eiect Misfeed Detection:
ON
v
2nd Drum Position SN
I
50°
Master Eject Sol.
I I
I
I
I
1----
30Q
~120-
Master Eject SW
I
I
I
I
I
I
Main Motor Reversing
I
Main Motor Forwarding
— 83°
I
Master Eject
Motor Reversing
When the master
I
I
1st
master
2nd Master
A
Eject Process
7'
eject switch is not activated within
tion during the 1st master eject process, the drum
direction to repeat the master eject process (2nd
above.
If the master eject switch [C] is not turned on again
master eject misfeed is detected.
Eject Process
I
120
degrees of drum reverse rota-
rotates 83 degrees in the forward
master eject proccess) as shown
in the 2nd master eject process, a
When a master misfeed occurs during the 2nd master ejection, rotation of the drum in
the reverse direction stops, the master eject motor turns off, and the main motor turns on
to drive the drum to the home position. After the drum returns to the home position, the
beeper sounds, and F and ~ indicators blink.
2-47