Ricoh C211 Service Manual page 744

K
"
TECHniC13L SEWICE BLJkAETKI
BULLETIN NUMBER 830/950-031
6/26/91
lzoomlKr
APPLICABLE MODEL SS830/950 PRIPORTS
................ . . . . . . . . . . . . . . . ........................ . . . . .....,, ..,,,,. . .. .. . ......... .... . . . . . ...
. . . . . . . . . . . . . . ........................ .. ...... . . . .. ....... . . . . . . . . . . . . . . .,,.,,
... .. .. . .............. ............... . . . ....... ..... .
..............................................
SUBJECT PAPER MISFEEDS/NO FEED
SYMPTOM:
Misfeeds or no paper feed may occur at the paper feed area.
CAUSE:
The one-way clutches inside the paper feed and second feed roller gears have worn the roller shafts causing
the clutch to slip resulting in failure to feed paper.
[B]
NOTE: This failure only occurs during operation; if operated manuall~ the paper will feed correctly.
SOLUTION:
Remove the paper feed roller gear [A] and the second feed roller gear [B].
Lightly sand the roller shaft's sutface at the contact point of the one-way clutch.
NOTE: If misfeeds continue, replace the one-way clutch and roller shaft.
UNITS AFFECTED:
All SS830/950 Priports exhibiting the above symptom.
u)
u)
CUS~OWWSH'?VICE GI?OUP
Office Products Support Division c
155 Passaic Avenue, Fairfield, New Jersey, 07004
201 /882-2000 FAX:201 1882-8531