Ricoh C211 Service Manual page 134

[c]
'm
,[E]
[A]
5. Disconnect the connector [D] of the encoder.
6, Insert the gauge [A] into the hole of the gear [E].
7. Turn on the LED "-2" of the Image shift indicator on the operation panel,
Then gradually turn the shaft of the encoder [B] in the "O"position direction
and stop it as soon as the "O"position LED lights.
8, In the above condition, set the encoder and tighten the allen screw [F] to
mount the shaft of the encoder with the gear [E], Then remove the gauge [A]
and connect the connector [C] of the image shift motor,
9. After adjustment, make prints to confirm the image position.
5-22