Table of Contents
Advertisement
SAFETY REQUIREMENTS: HYDRACTIVE 3 HYDRAULIC SUSPENSION
IMPERATIVE: Do not operate on the hydraulic circuit without
making the prssure drop (see corresponding operation).
Engine running:
- Do not operate on the hydraulic suspension circuit.
- Always remain out of range of any possible projections of fluid, as these
could cause serious injuries.
NOTE: In the event of contact of LDS fluid with the eyes, rinse them
with copious amounts of water and seek specialist advice.
NOTE: In the event of lengthy contact of LDS fluid with the skin, wash it
with soap and water.
WARNING: After the engine has stopped, wait 30 seconds before
commencing any operation.
IMPERATIVE: Do not remain underneath the vehicle during an operation
to adjust vehicle heights or during actuator (electrovalve) tests.
Cleanliness requirements.
WARNING: Non respect of the cleanliness requirements may cause a
contamination of the circuit and a malfunctioning of the suspension.
Preliminary operations.
The work area must be kept clean and uncluttered.
The technician must wear clean overalls.
Components being stored during the repair must be protected from dust.
The tooling required for an operation on the suspension system should
always be cleaned prior to the operation.
During the operation.
Before operating on the suspension circuit, proceed to clean the
hydraulic components and unions.
IMPERATIVE: Approved cleaner: SODIMAC degreaser.
IMPERATIVE: After a dismantling, immediately blank the hydraulic
components and unions with plugs. The plugs should be used for
one operation only.
Any component that has been removed must be plugged and placed in
a clean plastic bag.
IMPERATIVE: After a dismantling, any cleaning using compressed
air or products is strictly prohibited. Any LDS fluid that is collected
must not be re-used. Ny top-up must be done with new fluid.
301
C5
Advertisement
Table of Contents
