C5
CHECKING AND SETTING THE VALVE TIMING
Engine: 4HX
Checking the setting of the valve timing (continued).
IMPERATIVE: If it is impossible to line up the marks on the chain and on the camshaft drive
pinions, restart the camshaft setting (see operation for removing and refitting camshafts).
If the marks on the chains and pinions are coinciding, continue the checking operations.
Peg:
B1BP298C
- The crankshaft, using tool [2].
- The camshaft pinion, using tool [5].
IMPERATIVE: Should it be impossible to peg the camshaft, check that the offset between the cam-
shaft pinion hole and the pegging hole is not more than 1 mm (use a screw 7 mm in dia.).
If the offset is more than 1 mm, restart the setting of the valve timing (see corresponding operation).
Remove the tools [2] and [5].
B1EP15AD
175