Table of Contents
Advertisement
C5
B1BP2XLD
B1EP1FPC
CHECKING THE VALVE TIMING
Additional operations.
Refit:
- The inlet valve cover (7).
- The 16 fixing screws and the 2 screws at refs. 1 and 2 for the camshaft bearing caps cover.
- The camshaft position sensor (without tightening its fixing screw).
Tighten the 19 screws
Adjusting the camshaft position sensor.
Peg the engine flywheel, using tool [2].
Sensor re-used:
- Position a drill Ø 8,5 at "e" (between the inlet valve cover (7) and the camshaft position sensor (9)).
- Tighten the screw (8)
- Remove the tool [2].
New sensor:
- Place the camshaft position sensor (9) in contact with the target (camshaft pinion).
- Tighten the screw (8)
- Remove the tool [2].
Complete the refitting.
166
Engines: RHL - RHR
: 9 ± 0,1 m.daN (in the sequence indicated).
: 2 ± 0,2 m.daN.
: 2 ± 0,2 m.daN.
Advertisement
Table of Contents
