Removing The Dc Power Supply - Avaya 8800 Maintenance Manual

Removing the DC power supply

Use the following procedure to remove the DC power supply.
For more information about removing the DC power supply, see the job aids following the
procedure.
Procedure steps
Caution:
To maintain proper cooling, never operate the chassis with an empty power supply bay. If
you replace a failed power supply and you have no power filler panel, leave the failed power
supply installed until a replacement power supply is available.
1. To remove a DC power supply from the 8010co chassis with bezel model 312096-
2. Turn the power supply switch to the off position.
3. Disable the incoming power from the DC input power source. You may need to
Routine Maintenance
A installed, remove the bottom front bezel.
Important:
If you replaced bezel 312096-A with the modified bezel model 321325-A, you
need not remove the bezel.
switch a circuit breaker or turn off the DC input power source.
Voltage:
Risk of injury by electric shock
Removing the DC power supply
March 2011 61