Installing A Module - Avaya 8800 Maintenance Manual

Chassis slots and backplane cleaning
Procedure steps
1. Locate the slot where you want to install the filler panel.
2. Insert the filler panel into the slot (8010co chassis), or place the filler panel over the
3. Tighten the two screws with a Phillips screwdriver.

Installing a module

Install an Ethernet Routing Switch 8800/8600 module with the power on or off. If you install a
module in the same chassis slot where the same type of module was previously installed, the
previous configuration is maintained for that module in that slot. Otherwise, a module installed
in an Ethernet Routing Switch 8800/8600 chassis is reset to factory defaults.
Electrostatic alert:
Risk of equipment damage
Electrostatic discharge can damage hardware. For more information, see
and switch behavior considerations
Use the following procedure to install an Ethernet Routing Switch 8800/8600 module.
Procedure steps
1. Locate the slot where you want to install the module.
2. Remove the installed module or the filler panel.
3. Make sure that the insert and/or extract levers are extended away from the front of
4. Slide the module into the slot using the slot module guides.
5. Slide the module into the chassis until its connector panel touches the chassis back
6. Rotate the insert/extract levers to seat the module backplane connectors.
7. Using a Phillips screwdriver, tighten the two captive screws to secure the module
40 Routine Maintenance
slot (8003-R, 8006, or 8010 chassis).
the module.
panel.
to the chassis.
Make sure that both screws are tight for proper module operation.
on page 35.
Module removal
March 2011