Cleaning Fans Trays Or Cooling Modules In An 8006 Or 8010 Chassis - Avaya 8800 Maintenance Manual

2. Wait 10 seconds for the fans to stop turning. Pull the fan tray out of the chassis.
3. Vacuum the fans.
4. Slide the fan tray into the chassis until the connectors at the rear of the fan tray
5. Tighten the captive screws to fasten the fan tray to the chassis.
6. With the chassis power on, verify that the green status LED is lit.
Cleaning fans trays or cooling modules in an 8006 or 8010
chassis
Routine Maintenance
Grasp the fan tray at the middle of the front panel and be careful to keep your
fingers out of the fan blades.
engage.
The fans start turning when the chassis is powered on and the fan tray connectors
are fully engaged.

Cleaning fans trays or cooling modules in an 8006 or 8010 chassis

March 2011 23