I/O module replacement procedures navigation
•
Removing a module
•
Installing a module
•
Job aid: Hot swapping an I/O module
Removing a module
Remove a module to clean the chassis slots or backplane.
Removing a module takes three to five minutes.
Prerequisites
• Before you remove an 8692 or 8895 SF/CPU module, back up your configuration. If the
chassis has only one SF/CPU module and you remove that module, the switch does not
operate.
• Ensure that traffic is not traversing the module. First, disable the module. For further
instructions, see Avaya Ethernet Routing Switch 8800/8600 Configuration — Ethernet
Modules, NN46205-503.
Warning:
Risk of eye injury
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected
to a light source.
Electrostatic alert:
Risk of equipment damage
Electrostatic discharge can damage hardware. Follow ESD procedures to protect your
equipment from damage.
Caution:
Rick of electromagnetic interference
Routine Maintenance
on page 91
on page 93
on page 94
I/O module replacement procedures navigation
March 2011
91