Installing The Power Supply - Avaya ERS 4000 Series Installation Job Aid

Connect the AC power cord to the back of the switch, and then connect the cord to a power
outlet.
Figure 1: Connecting the AC power cord to the Ethernet Routing Switch 4000 Series
Connect the AC power cord to the back of the switch, and then connect the cord to a power
outlet.

Installing the power supply

You must install at least one power supply before using the switch. Some ERS 4000 Series
models can support an optional second power supply for redundancy and load sharing.
To install the power supplies into your switch, perform the following procedure.
1. Insert each power supply into a rear power supply slot. If a blanking plate covers
2. Verify that each power supply is fully seated in the slot. Secure the power supply
3. Once you have installed at least one power supply, you can connect the power cord
the required power supply slot, remove the plate before inserting the power
supply.
with the two thumb screws.
to a power outlet.
Installation preparation
November 2013 11