Connecting A Dc Power Source To A 5600 Series Switch - Avaya 5000 Series Installation Manual

Ethernet routing switch

Hide thumbs Also See for 5000 Series:

Troubleshooting manual (222 pages)

Installing (84 pages)

Manual (64 pages)

Table Of Contents

100

101

page of 101

/ 101
Contents
Table of Contents
Bookmarks

Table of Contents

Procedures for installation of the switch

Prerequisites

Electrostatic discharge can damage the components on circuit boards. When you unpack the

converter module, take the following precautions to prevent damage to the board:

• Do not remove the converter module from its antistatic plastic bag until you are ready to

install it. Store or ship the converter module and components in antistatic packaging.

• Check the converter module for damage. If you find damage, contact your sales or

customer service representative at the organization from which you purchased the

equipment.

• Use proper grounding techniques when you install the converter module. You can use a

foot strap and grounded mat or wear a grounded static discharge wrist strap.

Warning:

Removal of the power cord is the only way to turn off power to 5000 Series switches. The

power cord must always be connected in a location that can be accessed quickly and safely

in case of an emergency.

1. Make certain you are properly grounded electrically. See

2. The 5000 Series switch has a blank plate covering the converter module slot on the

3. Set aside the blank plate and the screws. If you remove the converter module for

4. Holding the converter module by the sides, slide the converter module into the 5000

5. Fasten the converter module screws to the switch using a screwdriver.