Siemens SITRANS P300 Operating Instructions Manual page 37

Procedure
To connect the transmitter, proceed as follows:
1. Strip approx. 14 cm of the cable.
2. Unscrew the cover of the electrical cable compartment.
3. Insert the cable set via the cable gland through a guide channel.
4. Connect the strands to the supply terminals (1) "+" and "-".
5. If you have a stainless steel cable gland, place the shield on the cable gland (2B).
6. Screw the cover back into place.
SITRANS P300 with HART communication
Operating Instructions, 06/2005, A5E00359579-02
The guide channel connects the cable gland with the cable compartment.
Observe the polarity when doing this.
If you have a plastic steel cable gland, place the shield on the shield support (2A). The
shield support is electrically connected with the housing.
Connecting
5.2 Connecting the transmitter
5-3