Figure 7-1
Measurement type "Pressure"
DV
Device Variable
PV
Primary Variable
SV
Secondary Variable
TV
Tertiary Variable
QV
Quarternary Variable
7.4.5
Customized characteristic curve
Introduction
The customized "characteristic curve" is continuously active as an identical function in the
two following measurement types "Level" and "User". This means that it always provides a
result for the following function, thus also influencing the measured value status of the
affected device variables.
In the device, the characteristic curve vertices are only provided once in the non-volatile
memory. Therefore, if the measurement type is changed, you will usually need to adjust the
characteristic curve accordingly.
The characteristic curve function requires the input of at least two and up to 30 characteristic
curve vertices, entered as pairs of values x%;y%. The values for the x-coordinate are only
SITRANS P300 with HART communication
Operating Instructions, 06/2005, A5E00359579-02
MA
Zero value
ME
Limit value
Operating functions via HART
7.4 Selecting the measurement type
7-5