Mitsubishi MELSEC Q Series User Manual page 220

7 PROCEDURE BEFORE STARTING THE DATA LINK
When performing
parameter setting with
GX Developer
Set the parameters with the GX Developer
(see Section 6.3, 6.4, 6.5, 6.6).
(1) When remote net ver. 1 mode is used
(a) Network parameters
(see Sections 6.3.1 and 6.3.3)
(b) Automatic refresh parameters
(see Sections 6.3.2 and 6.3.4)
(2) When remote net ver. 2 mode is used
(a) Network parameters
(see Sections 6.4.1 and 6.4.3)
(b) Automatic refresh parameters
(see Sections 6.4.2 and 6.4.4)
(3) When remote net additional mode is used
(a) Network parameters
(see Sections 6.5.1 and 6.5.3)
(b) Automatic refresh parameters
(see Sections 6.5.2 and 6.5.4)
(4) When remote I/O net mode is used
(a) Network parameters
(see Sections 6.6.1)
(b) Automatic refresh parameters
(see Sections 6.6.2)
Register the parameters to the PLC CPU
Set the PLC CPU RESET switch from "RESET" to
"Middle position" or turn the power from OFF to ON
7
7 - 2
From the previous page
Set the PLC parameter with the GX Developer.
(see Section 6.7)
Create a program in which the RLPASET
instruction is used.
(see Section 6.7)
Register PLC parameter/program to the PLC CPU
Set the PLC CPU RESET switch from "RESET" to
"Middle position" or turn the power from OFF to ON
Turn the RUN/STOP switch of the PLC CPU
to "RUN"
Check operation using the LED display
(master station):
When data link is normal: L RUN LED is lit
When the data link is faulty: L ERR LED is lit
Check the connection status of each module
(line test). (see Section 7.8)
Check operation using the CC-Link diagnosis.
(see Section 13.4)
Register the control program in the PLC CPU
Set the PLC CPU RESET switch from "RESET" to
"Middle position" or turn the power from OFF to ON
System operation
End
MELSEC-Q
When performing
parameter setting with
dedicated instruction
7 - 2