AMERITECH AM8a Instruction Manual page 97

RS232 Entries and Printouts (18-0037) AM8a Instruction Manual
The first two RS232 commands are equivalent to the RECALL and STORE key functions on the
front panel for SETUP selected. The remaining commands are listed in the order of the
equivalent AM8a front panel LCD menu displays as the MENU, FIELD, and VALUE keys are
pressed.
The block to the right of the command shows menu text (sufficient for identification) and the
selection-alternates (as displayed). Default values (factory-supplied) are shown within "<>";
not part of the menu display.
A command begins with an "(" followed by a three-letter code and, optionally, an "=" sign,
and either a two-digit code or a parameter value. A command ends with a ")".
To display a menu, type only a command code for a parameter on the menu; e.g., (CTD) or
(CEM) for the TEST SET: ... menu. To print the menu, type the print-display command, (PDS).
To change a parameter, type the command for the parameter, an "=" sign, and a code value
(leading 0 may be omitted). E.g., (CTD=1) to set the MODE:IMITATE to "switch"; or a
parameter value, e.g., (CTH=5) to set the PCM:CHAN to channel 5. Parameter change
commands will not display the menu. If the menu is already displayed, the change will be
seen.
To display a menu that has been changed, enter the display command; e.g., (CTH), type the
print-display command (PDS).
Manual subsection numbers where the parameter is described in detail are shown in bold type
following the parameter description; e.g., 2.1.1. A (1), (2), or a (3) following the subsection
number indicates that an additional menu must be displayed; e.g., PCM CONFIG 1 and PCM
CONFIG 2. An (@) following the subsection number indicates that the parameter must be
changed by the operator, not stored or recalled.
MF(R1) digits will not be seen if DIALTONE is used as a Start Signal.
NOTE:
February 10, 2000 0037-S07.L_
7-8