Table of Contents
Advertisement
AM8a Instruction Manual
x
signifies the end of the call progress tone. Selecting this for analysis will display
the Level and Frequency for each of the tones.
00:00.756
00:00.501
is SLC®96 II Trunk De-assignment LDS to RT.
y
1.2.3 Dialed Digits (O - 9, *, #, A, B, C, D): Digits appear whenever a valid dialed digit is
detected. A digit is considered valid if it meets the following criteria:
•
The level of a tone dial digit exceeds the Threshold programmed in the ANALYSIS
Setup menu.
•
The Low and High band frequency components must be within + 3.5 % of the
nominal frequency for Tone Dial digits.
•
The Speed is between 5 and 25pps and the % Break is between 40 and 85 % for
Pulse dialing.
•
A KP digit must be received before any other MF digit will be analyzed.
•
An ST, ST3P, STP, or STP2 digit (ST, A, B, or C key) must be received to end the
MF digit analysis.
The following are examples of digit events and details:
EVENT
5
00:13.385 T5
1
00:05.325 M1
2
00:04.603 P2
NOTE: MF(R1) digits will not be seen if DIALTONE is used as a Start Signal.
1.2.4 METER ([SHIFT][2]) Key: When the METER key is pressed, measurements and test
statistics are available for voltage, current and PCM evaluations, including phase
relationships between two T-1 spans. Use the MENU and VALUE keys to select the
Meter mode. Section 6 describes the meter functions.
0037-S01.L_19
(18-0037)
CP End
-17/480 -16/620
DT End
-13/350 -13/440
DETAIL
-06/770
-06/1336
-07/700
-07/900
09.9pps
56%
1-7
Front Panel Operation
0059/0060
DTMF
0070/0071
MF(R1)
699ms
Pulse
February 10, 2000
Advertisement
Table of Contents
