Recall Setups; Recall Setup Parameters; Recall Auto Dial Sequence; Speakerphone/Audio Monitor - AMERITECH AM8a Instruction Manual

Pcm/vf call analyzer

Table of Contents

Front Panel Operation

1.10 RECALL SETUPS

RECALL is used to recall stored Configuration, Emulate, and Analysis parameters when in a

Setup mode. It may also be used to recall pre-stored "Auto Dial" numbers when Emulating

Term/Line equipment while in the Events Display mode.

1. Select one of the Setup modes. (CONFIG'N, EMULATE, or ANALYZE, but not AUTO

DIAL.

2. Press [SHIFT] then [RECALL] then [n][n].

nn = 00 -19 for CONFIG'N

20 - 39 for EMULATE/ANALYZE

single [*] to recall ALL parameters before last power-off.

3. The AM8a will recall the setup based on the previously stored parameters for the

selected location.

NOTE: The AM8a must be Configured so that it is expected to dial (i.e: Emulate

Te/Line, and Off Hook).

1. Select EVENTS Display.

2. Press [SHIFT] then [RECALL] then [Auto Dial location (0 - 9)] or ["*"] for Last

Number Dialed.

NOTE: Last Number Dialed accumulates all out-pulsed digits from "Off- Hook" to

"On-Hook" for each call sequence.

The speakerphone is located on the front panel, labeled TALK. The VOLUME control adjusts to

the level of the speaker. A handset must be plugged into the modular jack labeled HANDSET.

The TALK (ON/OFF) key LED must be lighted.

1.11.1 Speakerphone in talk mode: To use the speakerphone the AM8a must be in

Emulation mode, because the Talk Mode is used to communicate with the person at

the other end of the line. In effect, this uses the AM8a as a speakerphone itself.

February 10, 2000

(18-0037)

AM8a Instruction Manual

1-16

0037-S01.L_

Table of Contents