Table of Contents
Advertisement
Analysis Parameters
4.2 STRT SIG (START SIGNAL) ANALYZE: EXPECTED TYPE
This menu is used to set the Start Signal EXPECTED by the AM8a when it is the calling party
(originator of the call). Dialtone will always be accepted, and the additional choices that can
be recognized are either wink or delay start.
STRT SIG :
ANALYZE:
Alternate:
4.2.1 dialtone/wink: This instructs the AM8a to EXPECT dialtone OR a wink as the Start
Dial. If a wink is received in less than 999 ms, the Events display will show a "W". If
the wink is not received within 999 ms, the Events display will show a "Pp". Within
the 999 ms, error reporting will depend on the parameters in the WINK STRT menu.
4.2.2 dialtone/delay: This instructs the AM8a to EXPECT dialtone OR a delay dial signal.
When the delay dial signal is received, the Events display will show a "Pp". Error
reporting will depend on the parameters in the DLY STRT menu.
4.2.3 dialtone/...: Dialtone will always be accepted as a start signal. If a dialtone is received,
an "X" will be displayed and error reporting will depend on the parameters in the DT
STRT menu.
4.3 DT STRT (DIALTONE START) ANALYZE: DIALTONE RCVDms (min/max)
This menu selects the DIALTONE RECEIVE timing. If dialtone is received as a Start Signal, it
must arrive within this threshold to be valid. If received outside of these limits, it will be
flagged as an error.
DT STRT :
ANALYZE:
Alternate:
February 10, 2000
(18-0037)
EXPECTED TYPE
dialtone/wink
dialtone/delay
DIALTONE RCVDms(min/max)
0 3000
0 to 9999 (1ms steps)
4-2
AM8a Instruction Manual
0037-S04.L_
Advertisement
Table of Contents
