Table of Contents
Advertisement
AM8a Instruction Manual
7.2.3 all calls,events & details: The EVENTS & DETAILS printout will provide the Event from
the first line of the Events Display, then the second line Analysis. This is repeated for
each event. Figure 7-2 is a sample of an EVENTS & DETAILS Monitor mode printout
(not based on EVENT printout described in the preceding sub-section). Figure 7-3 is a
sample for ring details. (These printouts are also typical of Manual long print from the
unit while in EVENTS DISPLAY mode.)
7.2.4 flawed calls,events only: Printout format is the same as shown in Figure 7-1. However,
only those calls outside tolerance specified in the ANALYZE setup menus will be output,
and an "*" at the end of the line will indicate the flawed call. Events which cannot be
recognized will be indicated with a "?".
7.2.5 flawed calls, events & details: Printout format is the same as shown in Figures 7-2 or
7-3. An "*" will be shown following those events which are outside of tolerance.
>
02:23:18 12-28-92 Monitor Term/Line
H
00:00:00
Off Hook
X 00:00.194 Dial Tone Begin
1
00:01.483 T1 -06/697 -06/1209 1483/0051
x 00:01.586 DT End -10/439
2
00:01.584 T2 -06/698 -07/1336 0050/0051
3
00:01.685 T3 -07/697 -06/1477 0050/0050
4
00:01.785 T4 -06/770 -06/1209 0049/0051
5
00:01.885 T5 -06/770 -06/1336 0050/0050
6
00:01.985 T6 -07/770 -06/1477 0051/0049
7
00:02.085 T7 -06/853 -06/1209 0050/0051
8
00:02.186 T8 -07/852 -06/1336 0050/0050
9
00:02.286 T9 -06/851 -07/1477 0049/0052
0
00:02.387 T0 -07/942 -06/1336 0050/0050
P 00:03.560
Supervision Begin
T
00:05.570
Tone Begin
t
00:05.798
Tone End -10 dBm
h
00:05.720
On Hook
p 00:06.245
Supervision End
Figure 7-2. Events & Details Printout (Monitor Mode)
0037-S07.L_58
(18-0037)
RS232 Entries and Printouts
-10/350
0697 hz
Event Details
Elapsed Time Reletive to Off Hook
Events generated from the switch
Events generated from the Term/Line
7-17
February 10, 2000
Advertisement
Table of Contents
