Table of Contents
Advertisement
Front Panel Operation
1.4.3 TALK ([SHIFT][
VALUE
under test.
•
ON: Enables the speakerphone function of the unit, using the front-panel
microphone and speaker. If a handset is connected, the front panel microphone
and speaker are disabled, and the handset functions as a telephone. To avoid noise
and false events, ON should not be enabled until the voice connection is made.
•
OFF: Speakerphone (or handset) is inoperative.
1.4.4 AUTO ([SHIFT][
VALUE
emulation. It is not used when set to Monitor.
•
ON: If EMULATE has been activated, pressing "SEIZE" key will cause the AM8a to
go Off Hook, and emulate the functions associated with the Calling Party (i.e.
detect the expected start dial signal and outpulse AUTO DIAL numbers) of the Trunk
Type programmed in the CONFIG'N Setup menu.
The AM8a will perform the functions associated with switching equipment of the
selected Trunk Type when an incoming seizure is detected. (i.e. provide
programmed start dial signal).
•
OFF: The AM8a generates individual emulation events only in response to manual
input.
1.5
MENU/DATA CONTROL KEYS
1.5.1 FREEZE ([SHIFT][B]) Key: Freeze allows the user to Freeze the Events Display to halt
the display update as new events are encountered. FREEZE is most useful in viewing
specific events embedded within a long call sequence.
•
ON: Events Display will indicate a "," to alert the user that a FREEZE has occurred.
In addition, the green LED for DISPLAY EVENTS (over [1] key) will go on steady.
•
OFF: To disable the Freeze, use the CANCEL key. The green LED above EVENTS
will resume flashing, and the Events Display will be updated as new events arrive.
February 10, 2000
(18-0037)
) Key: This control allows the operator to talk over the circuit
) Key: This control applies only when the AM8a is used in
1-10
AM8a Instruction Manual
0037-S01.L_
Advertisement
Table of Contents
