Table of Contents
Advertisement
Technical Specifications
Line Signaling
Detect and generate all of these line signals:
On Hook
Off hook
Wink
Flash
Unbalance (generate only)
Ringing
Ground Start (tip and ring)
Answer supervision (reverse battery)
EMULATION
User-controlled parameters for circuit emulation. When shown as a range, parameters are
selectable in unit steps, unless otherwise noted.
Digital Ports
Impedance:
Analog Office Battery
Voltage:
Current:
Analog Loop
DC Loop Length:
DC Hold Resistance:
AC Impedance:
Ringer Load:
Ringer Generation
Voltage:
Frequency:
Load:
Ring Trip:
February 10, 2000
(18-0037)
100 Ω at 1.544 megabits-per-second bipolar PCM
(switches to 1K Ω in DSX monitor mode)
20 V to 72 V ±2%
120 mA maximum (not selectable)
0 to 2100 Ω, adjustable in 300 Ω steps
10 Ω, 330 Ω, 430 Ω
135 Ω, 600 Ω, 900 Ω, 1200 Ω at 300 to 3300 Hz
2.16 µF (IN or OUT). OUT= 24µF
2.0 type B ringer equivalents (2 REN)
30 Vrms to 105 Vrms ±4% in 5 Vrms steps
15.0 Hz to 70.0 Hz in 0.1 Hz steps
5.0 ringer equivalents ( 5 REN) maximum. (If no
battery option and AC input is less than 100 Volts,
unit will work with 3 REN or less. Loop Length
must be 1500 ohms or more.)
below 2100 ohms; 2100 ohm loop length will not
detect ring trip (Loop Closure, answer).
8-2
AM8a Instruction Manual
0037-S08.L_
Advertisement
Table of Contents
