Warranty, Service, And Calibration - AMERITECH AM8a Instruction Manual

AM8a Instruction Manual (18-0037)

Warranty, Service, and Calibration

9. WARRANTY, SERVICE, AND CALIBRATION
9.1 WARRANTY
AMERITEC Corporation warrants that its electronic instrument products are manufactured to
the highest commercial standards and are free from any defects in material or workmanship.
For a period of one (1) year from shipment, AMERITEC will repair, without charge to the
original purchaser, any unit which upon inspection by AMERITEC proves to be defective.
This warranty is the sole warranty offered by AMERITEC and is in lieu of all other
obligations or liabilities, including claims of consequential damage; however, an
EXTENDED WARRANTY PLAN may be purchased. For information contact an Ameritec
Sales Representative.
9.2 SERVICE POLICY
AMERITEC products are designed with plug-in printed circuit boards and modular
assemblies. Once a problem is localized, service is accomplished by PC board (or module)
replacement.
9.3 CALIBRATION POLICY
All AMERITEC products are manufactured to commercial standards and are calibrated with
equipment traceable to NIST (National Institute of Standards and Technology). With the
exception of component failures or abuse, AMERITEC instruments are designed to maintain
compliance with their published specifications throughout their service life.
While periodic calibration verification is normally not required, in critical applications it is
recommended that verification be accomplished annually.
Calibration verification is most efficiently accomplished by return of the equipment to the
AMERITEC factory where specialized test equipment is used. Field calibration verification is
not supported by AMERITEC.
0037-S09.L_50 February 10, 2000
9-1