Table of Contents
Advertisement
RS232 Entries and Printouts
•
Front panel key actions which are alternate-action toggles are controlled by a "+" for
ON or "–" for OFF. For PCM monitoring, the TIMS key has a three-position selection that
uses a "#", (e.g: "TI+" for TIMS ON, "TI#" for TIMS reverse jack connections, and "TI–" for
TIMS OFF).
•
Display menus will change as some commands are entered (unless the display has
been deactivated by an "(AY-)" command). A display can be printed with a (PDS) print-
display command.
•
If units are chained, the command "!u" (where u=A through O corresponding to
units 1 through 15) must precede commands to the unit (refer to 7.3.3).
7.1.1 Terminal Commands: The RS232 terminal commands are shown in Figure 7–1. These
commands do not correspond to keys on the unit. They control the interaction between
the terminal (or computer) and the RS232 port. Refer to 7.3.2 for information on
connecting terminal to unit.
7.1.2 Printer Commands: (PDS) and other commands for printing are listed in Figure 7-2.
This figure also identifies equivalent front panel actions. The formats of the printouts
are shown in the Figures described under 7.2.
7.1.3 SETUP Menu Commands for CONFIG, EMULATE, and ANALYZE: The RS232 SETUP
Menu commands are listed Figures 7-3, 7-4, and 7-5, which also provide a quick
reference to the Section 2, 3, and 4 sub-sections that provide detailed descriptions of
menu displays and parameter entries. These commands are the equivalent to front
panel key actions after the operator activates the [CONFIG'N], [ANALYZE], or
[EMULATE] key functions.
February 10, 2000
(18-0037)
7-2
AM8a Instruction Manual
0037-S07.L_
Advertisement
Table of Contents
