AM8a Instruction Manual
2.8
PRINT CONFIG
This menu selects what information will be printed when the automatic print mode has been
enabled.
PRINT :
CONFIG:
Alternate:
2.8.1 off: This selection AM8a will not automatically print the events and/or details that
have been analyzed.
2.8.2 all calls, events only: This selection will cause the AM8a to automatically print the
events it has analyzed. The printout will be output at the start of the next call
sequence. The printout will consist of the events of the call without any details.
2.8.3 all calls, events & details: This selection will cause the AM8a to automatically print the
events and details it has analyzed. The printout will be output at the start of the next
call sequence.
2.8.4 flawed calls, events only: This selection will cause the AM8a to printout the analyzed
events when a call sequence is outside the tolerance specified in the ANALYZE setup
menus. The printout will be output at the start of the next call sequence and will print
only the events of the call.
2.8.5 flawed calls, events & details: This selection will cause the AM8a to printout the
analyzed events and details when a call sequence is outside the tolerance specified in
the ANALYZE setup menus. The printout will be output at the start of the next call
sequence.
0037-S02.L_22
(18-0037)
AUTOPRINT
off
all calls,events only
all calls,events & details
flawed calls,events only
flawed calls,events & details
2-11
Configuration Parameters
February 10, 2000