Auto And Manual Dialing; Store Autodial Sequence - AMERITECH AM8a Instruction Manual

AM8a Instruction Manual

5. AUTO AND MANUAL DIALING

The AUTODIAL display provides a way for the operator to store ten dialed-number sequences,
each with a maximum of 60 characters. The Autodial is active when the AUTO mode has been
selected, [SHIFT then
VALUE

5.1 STORE AUTODIAL SEQUENCE

To store a dialing sequence in the Auto Dial:
1. Press [SHIFT] then [AUTO DIAL]. The display will indicate "AUTO DIAL MENU x"
with a digit (0-9) flashing. The example below shows MENU 1 with all possible
characters entered (30 characters per line; 60 characters maximum).
2. Use the
MENU
you would like to have dialed automatically.
3. Enter dialed digits with the keys [1] through [9], [0], [*, KP], [#, ST], and red-
labeled keys (requiring SHIFT-SHIFT) [A], [B], [C], or [D], depending on the dialing
mode to be used, for the number you will later dial.
Digits will be displayed as entered, from left to right. For editing an existing
number, use the
(over the existing one).
4. Special Autodial functions (such as WAIT DT, WAIT WINK, etc.) also shown in Red
under the input keys may be entered. These functions are summarized in the table
on the next page. Refer to 4.9.3 and 4.9.4 for the frequencies for the DTMF and MF
(R1) tones.
5. After completing step 3 and/or 4, exit the Autodial Setup by selecting a different
SETUP, or display EVENTS or METER.
0037-S05.L_34
(18-0037)
]. If AUTO has not been selected, all dialing will be Manual.
keys to select the desired MENU (0 - 9 or *) to enter the number
FIELD keys to move to a specific digit, and enter the new digit
5-1
Auto and Manual Dialing
February 10, 2000