Table of Contents
Advertisement
Front Panel Operation
This character signifies a new call:
Wink
Off Hook
>HW2125551212W8189155441Hhh
00:02.163 T5 -06/0770 -06/1336 0059/0060
Digit Analysis
(Digit selected from
Elapsed
1st line by using
Time from
underline bar cursor)
Off Hook
NOTE: A flashing field in the 2nd line indicates a value that is outside of the
range specified by the ANALYZE parameter
1.2.2 Events Display Character Set: A list of the possible characters which may be displayed
on the Events Display follows. Following each description is a sample of what the
second line of the display would show if the character were selected for analysis.
•
Upper-case characters represent the beginning of an event.
•
Lower-case characters represent the end of an event.
•
Flashing characters indicate the event originated from the switching (far end)
equipment.
•
Non-flashing characters indicate the event originated from the Te/Line (near end)
equipment.
NOTE: Some non-flashing events such as Tones on a 2-wire circuit may have
originated from either the switch or the Term/line equipment. The
direction of these events cannot be determined.
>
indicates the beginning of a new call sequence. ">" will appear only at the first
position if the CONFIG DISPLAY:MODE parameter is set for "new call reset". More
than one new call sequence (with its beginning ">" in some other position) is only
possible if the DISPLAY:MODE parameter is set for "manual reset" or "scroll". The
time and date of the event and setting from MODE:MODE parameter is shown on
the second line when this character is selected.
15:00:15 02-28-92 Emulate (or Monitor) Switch (or Term/Line)
February 10, 2000
(18-0037)
On Hook
Dialed Digits
Cursor
High-Band
Level/Frequency
DTMF
Low-Band
Digit
Level/Frequency
5
Figure 1-2. AM8a Events Display
1-4
AM8a Instruction Manual
Decoded signaling
Steady
Analog Terminal/Line
Character
(PCM near end) signaling
Analog Switch
Flashing
(PCM far end) signaling
Character
Tone Duration
Off-Time
0037-S01.L_
Advertisement
Table of Contents
