G056/G058 Nib Firmware Modification History - Gestetner G056 Service Manual

5,9 ENGINE FIRMWARE HISTORY
⇒

5.9.2 G056/G058 NIB FIRMWARE MODIFICATION HISTORY

DESCRIPTION OF MODIFICATION
• Beginning of mass production
Firmware modified to correct the following.
1. The NIB did not retrieve infinite lease
period setting in the NetWare 5 DHCP
server.
2. NIB buffer overflow when Remote Printer
Mode was selected.
3. The Web Status Monitor did not have the
correct link to IPP Authentication and
Password Change pages.
4. Localized wordings appeared after the
NIB reset were modified.
• Change in Specification: None.
Firmware modified to correct the following.
1. LPR printing through Mac OS X server
was not possible. (Note that Mac OS X
server is not officially supported.)
2. The Web Status Monitor had a spelling
mistake. ("decomes" ! "becomes")
3. The last page of a print job from Dazel
system (TCP port 9100) was not ejected
immediately.
4. Disconnecting the Ethernet cable
sometimes did not result in a timeout
error.
5. TCP/IP setup page in the Web Status
Monitor did not check some invalid IP
address and subnet mask settings.
6. DHCP lease period became 0 (zero)
when Solaris 2.6 was used as a DHCP
server.
7. A user name longer than 8 characters
caused garbage character display in the
"prnlog" result. This does not have any
adverse influence on print results.
8. Protocol Up/Down settings were
sometimes not activated after a change
was made.
Change in Specification:
The NIB logs Timeout error in IPP printing in
"syslog".
G056/G058
G056/G058 NIB FIRMWARE MODIFICATION HISTORY
FIRMWARE
LEVEL
First Production
G0585910 A
G0585910 B December 2000
G0585910 C January 2000
5-20
Rev.08/2001
SERIAL FIRMWARE
NUMBER VERSION
1.46
1.47
production
1.48
production
SM