Bit Switch Programming - Gestetner G056 Service Manual

PRINTER CONTROLLER SERVICE MODE

5.1.2 BIT SWITCH PROGRAMMING

Refer to section 5.2.2 of the service manual for the base model (G056/G058) for
how to program bit switch settings.
Bit Switch 01 - Not used (do not change any of these settings)
Bit Switch 02
No Description
0-3 Not used
Treatment of the last page
when printing a job with an
odd number of pages using
the duplex unit
4 0: (default): Last page not
fed through the duplex unit
1: Last page fed through
the duplex unit
5-7 Not used
⇒
Bit Switch 03
No Description
0-2 Not used
CAD printing line widths
0: OFF (default):
1: ON - CAD Printing line
3
widths (255 pens)
4-7 Not used
Bit Switch 04 - Not used (do not change any of these settings)
G073/G074
Do not change the setting.
0: The last page is not fed through the duplex unit, so
the last page faces the opposite way from other pages
in the job.
1: The last page is fed through the duplex unit, so the
last page faces the same way as other pages of the
job.
Set this switch to "1" when the customer wishes the last
page to be facing the same way as the other pages.
Do not change the setting.
Do not change the setting.
0: CAD printing line widths is OFF.
1: CAD Printing line widths (255 pens)
Set this switch to "1" when the customer wishes to print
HP G/L2 files correctly. (Requires controller firmware
version 1.09 or newer.).
Do not change the setting.
5-2
Function
Function
Rev. 04/2003
SM