Gestetner G056 Service Manual page 245

Mode Name Description
mm/inch mm/inch
display display
selection
ROM Update User mode
Disp "ROM Update"
display
selection
A3/11x17 A3/DLT double
Count count
Auto Off set Energy saver
on/off
Ulimit Auto Automatically
Set add user code
in the Web
Status Monitor
Memory clr Memory clear
Free run Free run
Input check Input check
mode
Output check
Output check
mode
Fusing err clr SC code reset
Serial Serial Number
number Programming
Service TEL Service station
number
programming
Set Network Job spool settings/ Interface selection for Ethernet and wireless LAN
HD Job Clear
SM
PRINTER ENGINE SERVICE MODE
Function /[Setting]
Display units (mm or inch) for custom paper sizes.
0: mm (Europe/Asia)
1: inch (USA)
Currently, user mode "ROM Update" is not used.
0: Display this user mode
1: Do not display this user mode
Note: Do not change the setting.
Specifies whether the counter is doubled for A3/11" x 17"
paper.
If "Yes" is selected, the total counter counts up twice
when A3/11" x 17" paper is used.
Switches the energy saver mode on/off.
0: Enable, 1: Disable
Note: This setting is the same as the user mode "Energy
Saver" in the System menu.
Determines whether the machine adds new user codes
in the User Management Tool in Smart Net Monitor.
0: Automatically added
1: Not added
Resets software counters and returns modes and
settings to their defaults.
Memory all clear: Clears all data
Eng: Clears the printer engine settings
SCS: Clears the systems settings
PRT: Clears user mode system settings
NCS: Clears the items listed in the "Host Interface"
section of the Configuration page.
The machine performs a free run.
Press [Enter] to start.
Press [Enter] to stop.
Please note that the machine will not stop immediately
after the [Enter] key is pressed.
Displays signals received from sensors and switches.
See the "Input Check" section for details.
Turns on electrical components individually for test
purposes.
See the "Output Check" section for details.
Resets a service call condition (for fusing unit errors).
Use to input the machine serial number.
(This is normally done at the factory.)
Program the service station number.
The number is printed on the meter-charge counter
report when the meter-charge mode is turned on.
Treatment of the job when a spooled job exists at power
on.
0: Data is cleared
1: Automatically printed
5-5 G073/G074