Gestetner G056 Service Manual page 78

PRINTER ENGINE SERVICE MODE
Service
Description
Mode
Toner end Toner near-end
sensor threshold
Cartridge Toner cartridge
info information
A3/11x17 A3/DLT double
Count count
Memory
Memory clear
clr
Free run Free run
Input Input check
check mode
Output Output check
check mode
Fusing err SC code reset
clr
Serial Serial number
number programming
Service Service station
TEL number
programming
Initializes the
HDD Init
HDD
Prog
Checksum
G056/G058
Threshold adjustment for the toner end
sensor.
Normally, do not change the setting.
Important: Turn the main switch off/on
after changing this setting.
Displays toner cartridge information.
Specifies whether the counter is
doubled for A3/11" x 17" paper.
If "Yes" is selected, the total counter
counts up twice when A3/11" x 17"
paper is used.
Resets software counters and returns modes and settings
to their defaults.
• Memory all clear: Clears all data
• Eng: Clears the printer engine settings (See Note 1 for
a list of the settings erased)
• SCS: Clears system settings (See Note 2 for a list of
the settings erased)
• PRT: Clears user mode system settings (See Note 3
for a list of the settings erased)
• NCS: Clears the items listed in the "Host Interface"
section of the Configuration page.
The machine performs a free run.
Press [Enter] to start.
Press [Enter] to stop.
Please note that the machine will not
stop immediately after the [Enter] key is
pressed.
Displays signals received from sensors
and switches.
See the "Input Check" section for
details.
Turns on electrical components
individually for test purposes.
See the "Output Check" section for
details.
Resets a service call condition (for
fusing unit errors).
After using this SP mode, turn the main
switch off and on.
Use to input the machine serial number.
(This is normally done at the factory.)
Program the service station number.
The number is printed on the meter-
charge counter report when the meter-
charge mode is turned on.
Initializes the hard disk. Use this only if
there is a hard disk error.
--- Designers' use only
Function
5-6
Setting
200 to 1000
100 ms/step
200 ms
Yes
(double count)
No
(single count)
SM