Gestetner G056 Service Manual page 246

PRINTER ENGINE SERVICE MODE
Mode Name Description
Set Network Job spool
(LPR)
Job spool (IPP)
Primary I/F
Current I/F
HDD Init Initializes the
HDD
Prog
Checksum
IEEE1394
IEEE802.11b Wireless LAN
available
channel setting
USB USB settings
Transfer Rate
Vendor ID
Product ID
Dev. Release
Num
Test Print Engine test
pattern print
Plug/Play Plug & Play
name selection
G073/G074
Job spool on/off (LPR).
0: Job spool off
1: Job spool on
Job spool on/off (IPP).
0: Job spool off
1: Job spool on
Interface selection for the Ethernet or wireless LAN when
both interfaces are available.
0: Ethernet
1: IEEE802.11b (wireless LAN)
Note: This setting is same as the user mode setting "LAN
Type" in the Network Setup of the Host Interface menu.
Displays the current interface setting (Ethernet or
wireless LAN).
Initializes the hard disk.
Use this only if there is a hard disk error.
DFU
---
DFU
Sets the maximum and minimum value for the wireless
LAN channel adjustment. DFU
[0 to 14]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting, or the machine may be
out of compliance with local regulations.
Adjusts the USB transfer rate.
HS/FS: High speed/Full speed auto adjust
(480Mbps/12Mbps)
FS Fixation: Full speed (12Mbps fixed)
Do not change the setting unless there is a data transfer
error using the USB high speed mode.
Displays the vendor ID. DFU
Displays the product ID. DFU
Displays the development release version number. DFU
Prints the test pattern that was selected in the "Test
Pattern" mode.
Select the plug & play name.
Function /[Setting]
5-6 SM