Gestetner G056 Service Manual page 79

Service
Description
Mode
Test Print Engine test
pattern print
Plug/Play Plug & Play
name selection
Meter Meter-charge
charge mode
Service Prints engine
Report summary
Operation Total engine
time rotation cycle
Total Controller total
count C counter display
Disp ROM ROM version
ver display
SM
PRINTER ENGINE SERVICE MODE
Function
Prints the test pattern that was selected
in the "Test Pattern" mode.
Select the plug & play name.
Enable or disable meter-charge mode.
Important: Turn the main switch off/on
after changing this setting.
Meter charge mode enabled:
• 'Replace Maintenance Kit' is not
displayed on the operation panel
when the PM counter runs out (the
technician replaces the
maintenance kit items)
• The meter charge counter is shown
immediately after the Menu key is
pressed.
• The technician must reset the PM
counter after replacing the fusing
unit.
Meter charge mode disabled:
• 'Replace Maintenance Kit' is
displayed on the operation panel
when the PM counter runs out (the
user replaces the maintenance kit
items)
• The meter charge counter is not
shown when the Menu key is
pressed.
• The PM counter resets automatically
after the user replaces the fusing
unit.
Prints the engine summary sheet.
Displays the total number of engine
rotation cycles made so far.
Note: One cycle is calculated as 3.7 s
of drum rotation. However, this counter
also includes idle rotations.
This counter is not reset at PM.
Displays the controller total counter.
This counter is used for meter charge,
and it appears when the user presses
the Menu key (if meter charge mode is
enabled).
It does not count up when certain items,
such as service reports, are printed (see
section 6.6.1. for a complete list of
conditions).
Displays the firmware version (system,
engine, and duplex).
5-7
Setting
Yes
(Enabled)
No
(Disabled)
G056/G058