Cylinder Head Cover - Suzuki drz 400E Service Manual

Install the dowel pins.
Place each camshaft journal holders and cam chain guide
into the correct position.
NOTE:
Camshaft journal holders marked "EX" are for the exhaust side
and those marked "IN" are for the intake side.
Tighten the camshaft journal holder bolts to the specified
torque.
Camshaft journal holder bolt:
NOTE:
When tightening the camshaft journal holder bolts, the piston
position must be at TDC on the compression stroke.

CYLINDER HEAD COVER

Thoroughly wipe off oil from the fitting surfaces of the cylin-
der head and cover.
Apply SUZUKI BOND "1207B" to the end caps of the cylinder
head cover gasket as shown.
For USA
99104-31140: SUZUKI BOND "1207B"
For the other countries
99000-31140: SUZUKI BOND "1207B"
Apply engine oil to both sides of the washer 1.
Lightly tighten the cylinder head cover bolts in diagonal stages,
and then tighten them to the specified torque.
Cylinder head cover bolt
Use a new washers 1 and cushion 2.
10 N·m (1.0 kgf-m, 7.0 lb-ft)
Initial: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Final: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
ENGINE
1
3-63
2