Suzuki drz 400E Service Manual page 104

3-62 ENGINE
NOTE:
Just before installing the camshaft into the cylinder head, apply
molybdenum oil solution to the camshaft journals and cam faces.
Also, apply engine oil to the camshaft journal holders.
Place each camshaft into the correct position.
NOTE:
Camshafts which are marked "EX" are for the exhaust side and
those marked "IN" are for the intake side.
With the "T" line aligned with the center of the hole, hold the camshaft steady and lightly pull up the cam
chain to remove any slack between the cam chain drive sprocket and exhaust camshaft sprocket.
The exhaust camshaft sprocket has an arrow marked "1" 1. Turn the exhaust camshaft so that the
arrow is aligned with the gasket surface of the cylinder head. Engage the cam chain with the exhaust
camshaft sprocket.
The other arrow marked "2" 2 should now be pointing straight up. Starting from the roller pin that is
directly above the arrow marked "2" 2, count out 15 roller pins (from the exhaust camshaft side going
towards the intake camshaft side).
Engage the 15th roller pin on the cam chain with the arrow marked "3" 3 on the intake sprocket. Refer to
the following illustrations.
NOTE:
The cam chain should now be on all three sprockets. Be careful not to move the crankshaft until the cam-
shaft journal holders and cam chain tensioner are secured.
15th pin
3
3
1st pin
2
1
2
1